Let say, I have the value 11001100 coming from the Slave and goes through the Master then go to the PC via SERIAL port, I want the GUI read that and interpret that as specific value and change the intensity of that block on the GUI. The sensor send the value to the ADC of the PIC and then send that value to the PWM port which control the LED then that same Digital value it will go to the PC via Master/Slave SPI communication. I.E.: I have one block of LED that shows me the intensity or brightness of the LED is full or half of the intensity and I want that same value or data show up on the screen with a delay of almost none. I need to make a GUI that can show what I see physically. Pretty much is like 16 LED boards in 4 by 4 config. I have a kind of project like a proximity matrix.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |